Page 130 Configuring ARP
ARP Table Configuration
Use this page to change the configuration parameters for the Address Resolution Protocol Table.
To display the ARP Table Configuration page, click Routing > ARP in the navigation pane, and then
click Configuration.
Figure 93. ARP Table Configuration Page
Table 70. ARP Table Configuration Fields
Click Apply to update the switch configuration. Your changes take effect immediately but are not
retained across a switch reset unless you click Save Configuration.
Field Description
Age Time The amount of time, in seconds, that a dynamic ARP entry remains in the ARP table before
aging out.
Response Time The amount of time, in seconds, that the device waits for an ARP response to an ARP request
that it sends.
Retries The maximum number of times an ARP request will be retried after an ARP response is not
received. The number includes the initial ARP request.
Cache Size The maximum number of entries allowed in the ARP table. This number includes all static and
dynamic ARP entries.
Dynamic Renew When selected, this option allows the ARP component to automatically attempt to renew
dynamic ARP entries when they age out.
To Next Page
Loading...
Need help?
General