System Time Pages 29
Table 7. Daylight Saving Time Configuration Fields
Click Apply to update the switch configuration. Your changes take effect immediately but are not
retained across a switch reset unless you click Save Configuration.
Field Description
Daylight Saving Time Select how DST will operate:
Disable—No clock adjustment will be made for DST. This is the default selection.
Recurring—The settings will be in effect for the upcoming period and subsequent years.
EU—The system clock uses the standard recurring daylight saving time settings used in
countries in the European Union.
USA—The system clock uses the standard recurring daylight saving time settings used
in the United States.
Non-Recurring—The settings will be in effect only for a specified period during the year
(that is, they will not carry forward to subsequent years).
When a DST mode is enabled, the clock will be adjusted one hour forward at the start of the
DST period and one hour backward at the end.
Date Range Set the following to indicate when the change to DST occurs and when it ends.
These fields are editable when Non-Recurring is selected as the DST mode:
Start/End Date—Use the calendar to set the day, month, and year when the change to/
from DST occurs. Or, enter the hours and minutes in 24-hour format (HH:MM).
Starting Time of Day—Set the hour and minutes when the change to/from DST occurs.
Recurring Date When Recurring is selected as the DST mode, the following fields display:
Start/End Week—Set the week of the month, from 1 to 5, when the change to/from DST
occurs. The default is 1 (the first week of the month).
Start/End Day—Set the day of the week when the change to/from DST occurs.
Start/End Month—Set the month when the change to/from DST occurs.
Starting/Ending Time of Day—Set the hour and minutes when the change to/from DST
occurs.
To Next Page
Loading...
Need help?
General