HT2000H_en_n.doc Page 10 of 167
1.3 Warning
Read the following warnings before unpacking or using the unit.
See paragraph 1.1 “Intended use and restrictions” and be sure you have understood
it.
See EU Declaration of Compliance enclosed with the autosampler.
Before removing the autosampler from the box, please carefully read paragraphs 3.1
“Unpacking and preliminary operations” and 3.2 “Autosampler assembly”.
Before switching the autosampler ON check the correct voltage.
Electrical Hazards. Every analytical instrument has specific hazards, so ensure you
read and comply with the following precautions.
Use only the power supply system supplied with the autosampler. The use of a
different system could cause damage to the equipment and/or compromise safety.
There are no operator-serviceable or replaceable parts inside the power supply. In
case of failure, contact the Technical Assistance Centre. Violations of these directives
imply the immediate invalidation of the warranty and service contract.
The supplied power cord must be inserted into a power outlet with a protective earth
contact (ground). When using an extension cord, make sure that the cord also has an
earth contact.
Do not change the external or internal grounding connections. Tampering with or
disconnecting these connections could endanger you and/or damage the
autosampler.
The product is designed and tested in accordance with international safety standards.
You do not need to make any changes to the electrical connections or to the chassis
of the autosampler in order to ensure safe operation.
Do not turn the autosampler on if you suspect that it has incurred any kind of electrical
damage or if it shows visible signs of damage. If, for any reason, the safety
protections were compromised or the autosampler shows visible signs of damage,
disconnect the power cord and contact an HTA representative. The power cord
connector is considered to be the disconnecting device of the product. Electrical
damage may have occurred if the autosampler shows visible signs of damage, or has
To Next Page
Loading...
