HT2000H_en_n.doc Page 77 of 167
• Rear Injector Depth: shows the needle insertion depth into the rear injector. This
parameter is shown only if the autosampler is set to work with the rear injector;
• Rear Injector Insertion Speed: shows the needle insertion speed into the injector. This
parameter is shown only if the autosampler is set to work with the rear injector;
• IP Address, Subnet Mask, Gateway: shows the LAN connection data (see paragraph
3.5.1.1 “Default IP address”).
Select “Exit” to exit from the “VIEW PARAMETERS” screen.
4.2 Setup
Access sequence: RUN>SETTINGS>SETUP
In the “SETUP” screen the following menus are available:
• Alignment: aligns injectors and edit rack settings (see paragraph 4.2.1 “Setup:
Alignment”);
• Syringe Installation: used to install the syringe (see paragraph 4.2.2 “Setup: Syringe
warmer assembly installation “);
• Manual Operation: moves the autosampler motors for diagnostic or emergency needs
(see paragraph 4.2.3 “Setup: Manual operations”
• Configuration: edits autosampler settings (see paragraph 4.2.4 “Setup: Configuration”);
• Service: maintenance operation on the autosampler (see paragraph 4.2.5 “Setup:
Service“).
Select “Exit” to exit from the “SETUP” screen.
4.2.1 Setup: Alignment
This is used to align the sample tray and GC injection port. Access sequence:
RUN>SETTINGS>SETUP>ALIGNMENT From this screen access the following sub menu:
• Analyzer Default: selects the correct analyzer on which the autosampler is mounted (see
paragraph 4.2.1.1 “Alignment: Analyzer Default “). If no analyzer has been selected, the
front and rear injector buttons will not be available;
• Front injector: aligns the front injector (see paragraph 4.2.1.2 “Alignment: Front Injector);
• Rear injector: aligns the rear injector (see paragraph 4.2.1.3 “Alignment: Rear Injector”).
• Touch Plunger Zero: to re-execute alignment procedure (see paragraph 4.2.1.4
“Alignment: Touch Plunger Zero”);
• Tray Install: to install and edit rack settings (see paragraph 4.2.1.5 “Alignment: Tray
Install”).
To Next Page
Loading...
