HTA HT2000H - Autosampler Controlled by LAN-Connected PC

HT2000H_en_n.doc Page 57 of 167
An activation key is required to enable communication with the autosampler. Every autosampler
has its own key which is associated with its serial number. Without the activation key, the software
can only be used in "DEMO" mode.
In the Demo mode you can not:
• run a sample list, a single injection or washes;
• read from/download to the autosampler methods, sequences and set up settings;
• set the key (for HT2100H only);
• see the virtual screen.
3.5.1 Autosampler controlled by LAN-connected PC
3.5.1.1 Default IP address
The factory Ethernet configuration of the autosampler is as shown below (it may be subject to
change):
1) IP Address:192.168.0.207
2) Subnet Mask: 255.255.0.0
3) Gateway: 192.168.0.1
4) Ports: 20101 (TCP), 20102 (TCP), 20201 (UDP)
The IT/ network administrator must verify that any software firewall installed on the PC is:
• disabled;
• or enabled, but is not blocking the “HTA Autosampler Manager” application and the ports
20101 (TCP), 20102 (TCP) and 20201 (UDP);
The IT/ network administrator must also be informed about the IP address, because it could be in
conflict with the adresses of other devices connected to the LAN or be outside the subnet segment
of the LAN. If necessary, you can change the IP configuration (see paragraph IP address/Subnet
mask modification3.5.1.3 “IP address/Subnet mask modification“).
3.5.1.2 Operations
To control the autosampler by PC, proceed as follows: