HT2000H_en_n.doc Page 138 of 167
9 Maintenance
Warning
These operations must be completed by competent personnel, properly trained in the
procedures described in this manual: any missing or different execution of the described
procedures can cause damage to the autosampler or to the person working on it.
However, in particular, pay attention to the moving parts such as the sledge, syringe, needle,
the cover of the oven etc...
For the sample handling, see paragraph 1.1 “Intended use and restrictions” and 1.3
“Warning”.
Warning
Some parts of the autosampler (oven, syringe, needle or vials) can work at high temperatures.
Be careful to avoid burns. Allow these parts to cool down before handling them.
9.1 Ordinary maintenance
The autosampler does not require periodical maintenance other than that described below.
9.1.1 Cleaning of vial rack/tray
For HT2000H/HT2000HT:
• Open the tray (7.5 “Load and Unload Sample Vial”);
• Remove the rack from the tray;
• Clean the rack and tray with a non-abrasive detergent solution.
• Dry with a dry cloth.
• Replace the rack inside the tray and close the tray.
For HT2100H:
To Next Page
Loading...