HT2000H_en_n.doc Page 72 of 167
Figure 83: System integrity tool installation_4
3.7 Preparing sample vial
Warning
These operations must be completed by competent personnel, properly trained regarding the
procedures described in this manual: any missing or different execution of the described
procedures can cause damage to the autosampler or to the person working on the equipment.
For sample handling see paragraph 1.1 “Intended use and restrictions”.
For HT2000H/HT2000HT:
• Follow the instruction for sample loading 7.5 “Load and Unload Sample Vial”);
• Prepare the sample vial;
• Put the vial in the rack.
For HT2100H:
• Press “MOVE” on the keypad, (see paragraph 6.1 “Keys“), so the turret rotates and the sample
rack is accessible;
• Prepare the sample vial;
• Put the vial in the rack.
To Next Page
Loading...
