HT2000H_en_n.doc Page 156 of 167
10. Insert the protective cushions.
Figure 130: Insert the cushions
11. Close and seal the box using suitable adhesive tape.
10.2 Autosampler disposal
If the autosampler has to be disposed of, perform the following:
Execute the uninstalling procedure described in 10.1 “Autosampler uninstalling”.
Place the autosampler and its accessory parts in the original packaging or into another type of
packaging suitable for transport. If you need further information, contact your dealer or the
Technical Assistance Centre.
10.3 Disposal instructions
To Next Page
Loading...
