HTA HT2000H - Page 166

HT2000H_en_n.doc Page 170 of 167
Figure 91: Plunger locker removing 83
Figure 92: Retaining nuts removing 83
Figure 93: Syringe warmer assembly removal 84
Figure 94: Syringe warmer assembly positioning 85
Figure 95: Retaining nuts repositioning 86
Figure 96: Plunger locker positioning 86
Figure 97: Sliding lid closing 87
Figure 98: Syringe volume setting screen 87
Figure 99: Screen type 7 90
Figure 100: Home screen: Standard user Interface 111
Figure 101: Home screen: Quick User Interface 112
Figure 102: HT2000H/HT2000HT rack placing 117
Figure 103: Damage to the syringe needle 130
Figure 104: Syringe inspection 131
Figure 105: Tray opening by hand 132
Figure 106: Connection troubleshooting 133
Figure 107: Set network parameters 134
Figure 108: Exploded view of the syringe warmer assembly 140
Figure 109: Main screw 141
Figure 110: Removing the upper cover and the syringe plunger 142
Figure 111: Syringe warmer assembly disassembling_1 142
Figure 112: Syringe warmer assembly disassembling_2 143
Figure 113: Lower spacers positioning 143
Figure 114: Insulating gasket positioning 144
Figure 115: Upper spacer positioning 144
Figure 116: Syringe holder positioning 145
Figure 117: Syringe barrel mounting inside the heating body 145
Figure 118: Syringe plunger replacing 146
Figure 119: HT syringe needle removal 149
Figure 120: HT syringe needle installation 150
Figure 121: HT syringe plunger replacement 150
Figure 122: Apply the tower protection 153
Figure
123
: Apply the polythene bag
Figure 124: Apply the protection belt 154
Figure 125: Position the lower cushions 154
Figure 126: Position the accessory boxes 154
Figure 127: Position the upper cushions 155
Figure 128: Close the packaging by adhesive tape 155
Figure 129: Put the autosampler in the box 155
Figure 130: Insert the cushions 156
Figure 131: 20ml sample vial dimensions 162
Figure 132: 10ml sample vial dimensions 163
Figure 133: 6ml sample vial dimensions 163
Figure 134: GC Connector 166