HT2000H_en_n.doc Page 64 of 167
Figure 72: HTA Autosampler Manager screenshot
3.5.1.3 IP address/Subnet mask modification
If it necessary to modify the IP address/Subnet mask proceed as follows:
1) Connect the autosampler directly to the PC, inserting the Ethernet cable provided with the
autosampler in the port indicated with the number 4 in Figure 22 and then into the Ethernet
port of the PC (see paragraph 3.3.3 “Electrical connections”);
2) The IT/ network administrator must verify that the PC you are working with has a static IP
address (do not work with DHCP);
3) Run “HTA Autosampler Manager”;
4) “Open” your autosampler window (see paragraph 3.5.1.2 “Operations”, point 16) and 17))
and from the Set up-Communication window change the IP address or the Subnet mask as
shown in the figure below (press “Edit” button to enable the modification and then
“Download the autosampler” to make the change effective) In order to get information
about a valid IP address/Subnet mask and other related information, please ask your IT/
network administrator.
Figure 73: P address/Subnet mask modification
5) Follow the wizard to end the procedure (the instrument has to be switched off/on). If a
communication problem occurs, close the software and run it again.utosampler connected
directly to the PC.
To Next Page
Loading...
