HT2000H_en_n.doc Page 81 of 167
Figure 87: Syringe positioning screen
3. When the autosampler is ready, the following screen appears:
Figure 88: Syringe remove and installation screen
4. The autosampler should be automatically positioned in a convenient position to allow the
syringe warmer assembly installation. If this position is OK, proceed to step 5.
5. If the position is not convenient, tap “MANUAL” to display the following screen. From here,
it is possible to move the plunger, turret and needle in order to reposition the autosampler
to your desired position.
To Next Page
Loading...
