Silkscre
en
Indicator/
Button
State Description
Power button/
indicator
Power indicator
l Steady yellow: The server is in the standby state.
l Steady green: The server is properly powered on.
l Blinking yellow: The iBMC is starting.
l Off: The server is not connected to a power source.
Power button
l When the server is powered on, you can press this button
to shut down the OS.
l When the server is powered on, you can hold down this
button for 6 seconds to force the server to power off.
l When the server is ready to power on, you can press this
button to start the server.
UID button/
indicator
The UID button/indicator helps identify and locate a device.
UID indicator:
l Off: The device is not being located.
l Blinking blue: The device has been located and is
differentiated from other devices that have also been
located.
l Steady blue: The device is being located.
UID button:
l You can turn on or off the UID indicator by pressing the
UID button on the panel or by using the iBMC CLI or
WebUI.
l You can press this button to turn on or off the UID
indicator.
l You can press and hold down this button for 4 to 6 seconds
to reset the iBMC.
Health
indicator
l Steady green: The server is operating properly.
l Blinking red at 1 Hz: A major alarm has been generated on
the server.
l Blinking red at 5 Hz: A critical alarm has been generated
on the server.
FlexIO
presence
indicators (1
and 2)
l 1 and 2: The numbers 1 and 2 respectively represent the
two FlexIOs.
l Steady green: The FlexIO is properly connected.
l Off: The FlexIO is faulty or not in use.
TaiShan 2280 V2 Server
User Guide
2 Components
Issue 01 (2019-07-01) Copyright © Huawei Technologies Co., Ltd. 7
To Next Page
Loading...
Need help?
General