Change the initial iBMC U-Boot password
Step 1 Log in to the iBMC CLI over the serial port.
Step 2 Run the following command to restart the iBMC:
iBMC:/->ipmcset -d reset
The command output is as follows:
This operation will reboot IPMC system. Continue? [Y/N]:
Step 3 Enter y.
The system restarts.
Step 4 Press Ctrl+B immediately when the system displays the message
Hit 'ctrl + b' to stop autoboot: 1
Step 5 Enter the default password for the iBMC U-Boot.
The following command output indicates that you are logged in to the U-Boot.
u-boot>
Step 6 Run the following command to change the U-Boot password:
u-boot> passwd
The following information is displayed:
Enter old password:
Step 7 Enter the old password.
The following information is displayed:
Enter new password:
Step 8 Enter a new password.
The following information is displayed:
Enter the new password again:
Step 9 Enter the new password again.
If the command output is as follows, the password has been changed:
. done
Un-Protected 1 sectors
Erasing Flash...
. done
Erased 1 sectors
Writing to Flash... done
. done
Protected 1 sectors
password be changed successfully.
Step 10 Run the following command to exit U-Boot:
boot
----End
TaiShan 2280 V2 Server
User Guide
4 Setup
Issue 01 (2019-07-01) Copyright © Huawei Technologies Co., Ltd. 77
To Next Page
Loading...
Need help?
General