Table 15. MAP 0190: Forms Feed Problems (continued)
Step Questions/Actions Yes No
27.
Perform the tractor assembly service check. Go to
“Tractor Assembly Service Check” on page 325.
Is the service check OK?
Install a new tractor assembly in
the failing position (front or rear).
If the printer is still failing after
the tractor assembly has been
changed, install a new logic
board. For Model A00, see “Logic
Board - Model A00” on page 370.
For Models 001 and 002, see
“Logic Board - Models 001 and
002” on page 378. Or “Logic
Board - Model 003” on page 366.
If the printer is still failing after
the logic board has been
changed, install a new tractor
assembly cable.
Run T&D in automatic mode to
verify correct printer operation.
For Model A00, see “How To Run
the Test and Diagnostic (T&D)
Programs” on page 161. For
Models 001, 002, or 003, see
“How To Run the Test and
Diagnostic (T&D) Programs” on
page 201.
Repair, as needed.
Run T&D in automatic mode to
verify correct printer operation.
For Model A00, see “How To Run
the Test and Diagnostic (T&D)
Programs” on page 161. For
Models 001, 002, or 003, see
“How To Run the Test and
Diagnostic (T&D) Programs” on
page 201.
Chapter 1. Diagnosing Problems
119
To Next Page
Loading...
