Table 15. MAP 0190: Forms Feed Problems (continued)
Step Questions/Actions Yes No
35.
Check the sensor cable assembly for wear or damage.
Is it OK?
Install a new logic board.
Run T&D in automatic test mode
to verify correct printer operation.
For Model A00, see “How To Run
the Test and Diagnostic (T&D)
Programs” on page 161. For
Models 001, 002, or 003, see
“How To Run the Test and
Diagnostic (T&D) Programs” on
page 201.
Install a new sensor cable
assembly.
Run T&D in automatic test mode
to verify correct printer operation.
For Model A00, see “How To Run
the Test and Diagnostic (T&D)
Programs” on page 161. For
Models 001, 002, or 003, see
“How To Run the Test and
Diagnostic (T&D) Programs” on
page 201.
Chapter 1. Diagnosing Problems
124
To Next Page
Loading...
