EasyManua.ls Logo

IBM 5100 - Page 372

IBM 5100
389 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
jackshaft:
A mechancial device in the tape unit that
transfers motion from the motor
(via
a belt)
to
the
spindle.
KBD: Keyboard.
kVA:
Kilovolt amperes.
LED: Light emitting diode.
logical
record: A group
of
data independent
of
its
physical location.
loop:
A group
of
instructions that are executed
repeatedly.
LWR:
loop
write read.
MAP:
Maintenance analysis procedures.
MOl:
Maintenance and diagnostics integrated.
MHz:
Megahertz.
ms:
Millisecond.
N/C:
Normally closed contact.
N/O:
Normally open contact.
nonexecutable
ROS: Contains microinstructions that
are first loaded into
read/write
storage and executed
from there.
ns: Nanosecond.
NTF: No trouble found.
numeric
keys: That portion
of
the keyboard that
resembles a calculator keyboard.
pc:
Printed circuit.
pc
board:
A printed circuit board consists
of
electrical
circuits mounted on a board
to
distribute signals and
voltages.
PG: Parity generator.
PH: Polarity hold.
PLFP: Print line failure position.
POR: Power on reset.
0ยท2
power
on
reset: A signal occurring during power up,
used
to
reset all circuits
to
an
operational starting point.
PTX: Phototransistor.
RDDR:
Read
data daserializer register.
RDR:
Read
data register.
read
only
storage:
A storage whose contents are not
changed by computer instructions.
record: A group
of
related data items.
ROS:
Read
only storage.
RRA: Remove, replace, adjust.
SA:
Status byte
A.
SAR: Storage address register.
SB: Status byte
B.
scroll:
Move data on the display screen up or down;
SDR: Storage data register.
spindle:
A mechanical device
in
the tape unit
for
transferring motion
from
the jackshaft pulleys
to
th~
cartridge capstan.
steps:
An offset that occurs in a reel
of
tape when
exposed
to
extreme temperature drops.
supervisor: That part
of
the control program that
coordinates the
use
of
resources and maintains the
flow
of
processor operations.
sync:
Synchronize or synchronous.
syntax:
Structural rules
of
a programming language.
truncate:
To stop
an
operation at a specified point.
TS: Test status.
TSR: Transistor switching regulator.
TTL: Transistor-transistor logic.
TV
monitor:
An external display assembly that displays
the same information
as
the 5100
5-inch
display screen.

Table of Contents

Other manuals for IBM 5100

Related product manuals