PROCEDURE
FOR
LOADING DIAGNOSTICS
•
To
load DCP1:
1. Hold
theCMD
key
down
and press the HOLD
key.
2.
Hold the CMD key down and press the -
(minus) key.
• To load
DCP1
diagnostic mode:
1. Hold the CMD key down and press the * or x
(multiply) key.
• To
run
CMD 0 or 1 tape read tests:
1.
Press
the C key.
CAUTION
Do
not
insert the diagnostic tape cartridge until
instructed to do
so.
If
the cartridge is inserted too soon,
the tape may become creased.
2.
Hold the CMD key down and press the 0 or 1
key.
0=
Internal tape unit test without tape motion
1
= Internal tape unit test
with
tape motion
DCP2 is
now
loaded. Select and enter the desired MOl
number from the menu via the instructions on the
display. Press the
EXECUTE
key and
the
selected
diagnostic will run.
!
'-
/
To Next Page
Loading...
