5486MSum.fm Draft Document for Review October 18, 2004
806 IBM Eserver i5 and iSeries System Handbook
Note 1 CPW is now being used to measure the performance of all iSeries and AS/400e processors. The CPW value
is measured on maximum configurations. The type and number of disk devices, the number of workstation
controllers, the amount of memory, the system model, other factors, and the application being run determine
the performance that is achievable. All iSeries and AS/400e processors announced from September 1996
onward have only CPW performance measurements.
Note 2 External DASD can be attached using a System Products Division (SPD) card in the Expansion Unit.
Note 3 One line is used for Client Access Console or Operations Console if selected. The maximum is nine if
Twinaxial Console is selected.
Note 4 The #9364 must be configured with #9329 /#9330 (PCI) or #9331 (SPD). Therefore, these columns are
mutually exclusive.
Note 5 Maximum is 175.4 GB on the #2061 Processor.
Note 6 Any combination of Twinax or ASCII workstation controllers up to either maximum shown is allowed,
Maximums are not additive.
Note 7 Software group is determined by a combination of the processor and interactive feature. The following table
provides a cross reference.
Processor Interactive feature System feature code Software group
#2061 #1500 206A P10
#1501 206B P20
#1502 206C P20
#2062 #1500 206D P10
#1501 206E P20
#1502 206F P20
#1503 207A P20
#2063 #1500 207B P20
#1502 207C P30
#1503 207D P30
#1504 207E P30
#2064 #1500 207F P20
#1502 208A P30
#1503 208B P30
#1504 208C P30
#1505 208D P30
Note 8 The total number of internal tapes and CD-ROM per tower cannot exceed the maximum quantity shown for
internal tapes. The system maximum for internal tapes and CD-ROMs is 18.
To Next Page
Loading...
