Summary of earlier AS/400, AS/400e, and iSeries models 811
Draft Document for Review October 18, 2004 5486MSum.fm
Note 1 CPW is now being used to measure the performance of all iSeries and AS/400e processors. The CPW value
is measured on maximum configurations. The type and number of disk devices, the number of workstation
controllers, the amount of memory, the system model, other factors, and the application being run determine
the performance that is achievable. All iSeries and AS/400e processors announced from September 1996
onward have only CPW performance measurements.
Note 2 This total includes the MFIOP. The combination of internal and external IOPs cannot exceed this number.
Note 3 The maximum combination of 2440, 7208, or 9348 and Tape Libraries may not exceed four.
Note 4 Software group is determined by a combination of the processor and interactive feature. The following table
provides a cross reference.
Processor Interactive feature System feature code Software group
#2069 #1514 2D6B P40
#1510 2D6C P50
#1511 2D6D P50
#1512 2D6E P50
#2070 #1514 2E6A P40
#1510 2E6B P50
#1511 2E6C P50
#1512 2E6D P50
#1513 2E6E P50
Note 5 The system maximum for internal tapes and CD-ROMs is 18.
To Next Page
Loading...
