WSB-9152 PICMG 1.0 SBC
Page 152
CAUTION!
Do not accidentally disconnect the SATA drive cables. Carefully route
the cables within the chassis to avoid system down time.
7.2 Features and Benefits
Supports RAID levels 0, 1, and JBOD
Supports connectivity to two disk drives
Supported Operating Systems include: Windows 2000, Windows XP, Fedora
and Red Hat Linux
Graphical software for RAID management in Windows
7.3 Accessing the JMicron RAID Utility
To access the JMicron RAID Utility, please follow the steps below:
Step 1: Connect two SATA drives to the system. Ideally the two drives should be
identical, but two non-identical drives will work too.
NOTE:
Make sure the SATA drives are EXACTLY the same when they are
configured in a RAID configuration (JBOD, RAID 0 or RAID 1). If they
are not the same size, disk drive capacity is sacrificed and overall
performance affected.
Step 2: Enable SATA drives in BIOS. Access the AMI BIOS setup program. Open the
Advanced CMOS Setup menu. Go to the IDE configuration menu. Set “Sec,
SATA controller mode” to [RAID]. To enable the system to boot from the SATA
drives, go to the BOOT menu and set “Boot from SATA function” to [ENABLED].
Step 3: Save and Exit the BIOS.
To Next Page