10–17
Transpector CPM Operating Manual
Figure 10-25 Editing special bins not allowed
Removing Masses
Click Remove to remove an individual mass. (See Figure 10-26.)
Click Remove All to remove all of the masses. (See Figure 10-27.)
Figure 10-26 Remove
Figure 10-27 Remove All
10.6.1.2.2 Adding Masses
FabGuard Explorer allows masses to be added to the mass list for the sensor.
Dwell Time for New Bins
When collecting data with Bin Independent dwell times, the Dwell Time for New
Bins can be set to any value.
NOTE: The dwell time for each mass can be changed by editing the mass.
This new dwell time will be used for all newly created masses.
Figure 10-28 Dwell time for new bins
Add Mass
Adds a mass to monitor by identifying a specific mass in amu, either defining it
manually or using the auto select function to name the mass. After entering the
mass value in the Mass: box and selecting the Identity, click Add.
To Next Page
Loading...