Insightec Exablate 2100V1 - 2.8. Cyber-Security

SAFETY
Manual Part Number
42
Test
Standard
Class/Severity Level
Test
Result
Immunity from Electrical Fast transient
(EFT)
IEC/EN 61000-4-4
± 2 kV on AC main 3 phase
± 1 kV on 5 power & signal cables
Tr/Th – 5/50 ns 100 kHz
Complies
Immunity from Surge
IEC/EN 61000-4-5
± 2 CM / ± 1 kV DM
on AC mains, 3 phases
Tr/Th – 1.2/50 (8/20) µs
Complies
Immunity from conducted disturbances
induced by radio-frequency fields
IEC/EN 61000-4-6
3.0 & 6.0 VRMS
0.15÷80 MHz, 80% AM, 1 kHz
on AC mains, 3 phases & 4 power
& signal cables
Complies
Immunity from voltage dips, short
interruptions and voltage variations
IEC/EN 61000-4-11
AC mains:
0 % - 10 ms & 20 ms;
70% - 500 ms; 0% - 5 s
Complies
2.8. Cyber-Security
2.8.1. Cyber-Security Related Precautions
1. Only authorized personnel are allowed to physically access the Exablate workstation.
2. Maintain physical access control to the MR control room and the Workstation.
3. Maintain physical access restriction to the MR service area and the Equipment Cabinet.
4. Exablate Workstation username & password should not be printed or shared with anyone, except for
authorized users.
5. In case the WS and/or CPC hard drive/s physical security cannot be guaranteed in the MR control room
or the Equipment Cabinet room, detach with the dedicated keys the WS and/or CPC hard drive/s when
the system is not in use and store them in a safe and accessible controlled location.
6. USB devices (such as Disk on Key) should be used on Exablate workstation only by authorized personnel.
USB devices require prior malware scan (by Anti-Virus/Anti-Malware).
7. Do not use the USB port to charge other equipment.
8. Do not insert into USB ports unauthorized devices including radiofrequency (RF) transmitters.
9. Always shut down the Exablate system after completing a treatment/session (unless it is followed by
another consecutive session).