Affinity
2.0
Additional Information Page 258
Select protocol to use from the list allows you to select a test protocol
the current test session (see section 0 for more information about test
protocols).
Temporary Setup button allows for making temporary changes to the
selected test protocol. The changes will be valid for the current session
only. After making the changes and returning to the main screen, the
name of the test protocol will be followed by an asterisk (*).
NOTE: it will only be possible to change protocols that have been
created by the user. It is not allowed to modify the protocols that are
based on the IEC and ANSI standards. Therefore, Temporary Setup is
disabled for ANSI and IEC protocols.
List of historical sessions accesses historical sessions for comparison
purposes.
Toggle between Lock and Unlock the Selected Session freezes the
current
or historical session on the screen for comparison to other
sessions.
Go to Current Session button brings you back to current session.
Report Editor button opens a separate window for adding notes to the
current session (see section 0
). Note that after saving the session no
changes can be added to the report once the date has changed.
Single frequency button represents an optional
manual test that allows for pre-setting hearing aid gain
prior to HIT.
Place the hearing aid in the test box and press the
single frequency button. A 1000 Hz tone will then
appear allowing you to see the exact input and output
of the hearing aid. Press the button again to end the
test.
Simple view/Advanced view buttons toggle between an advanced
screen view (including the test and fitting prescription information on
the right hand side) and a more simple view with a larger graph.
To Next Page
Loading...
