IP-COM CPE6S - Access Control; Overview

Chapter 7 Wireless 131
7.3 Access control
7.3.1 Overview
The Access control function enables you to allow or disallow the wireless devices to access
the wireless network based on their MAC addresses. The CPE supports the following MAC
address filter rules:
− Disallow: It indicates that only the wireless devices with the specified MAC addresses
cannot access the wireless networks of the CPE.
− Allow: It indicates that only the wireless devices with the specified MAC addresses
can access the wireless networks of the CPE.
To access the page, choose Wireless > Access Control.
Parameters description
Name
Description
SSID
It specifies the SSID of this device. With the rule enabled, clients connected to the
network with this SSID will be controlled by the rule.
Access Control
It specifies whether to enable the Access Control function.
Mode
It specifies the mode for filtering MAC addresses.
−
Allow: It indicates that only the wireless clients on the access control list
can connect to the WiFi network of the CPE.
−
Disallow: It indicates that only the wireless clients on the access control list
cannot connect to the WiFi network of the CPE.
Access Control List