Chapter 7 Wireless 132
7.3.2 Example of configuring access control
Network requirement
A wireless network whose SSID is IP-COM_158810 has been set up in an estate. Only specific
members in this estate are allowed to connect to the wireless network.
The Access Control function of the CPE is recommended. Assume that the users have three
wireless devices whose MAC addresses are C8:3A:35:00:00:01, C8:3A:35:00:00:02, and
C8:3A:35:00:00:03.
Configuration procedure
1. Choose Wireless > Access Control to enter the configuration page.
2. Enable the Access Control function.
3. Set the Mode to Allow.
4. Enter the MAC address, which is C8:3A:35:00:00:01 is this example, and click Add.
If the wireless devices to be controlled are connected to the CPE, click Add online devices to add them to the
access control list quickly.
5. Perform Step 4 to add the other two MAC addresses.
6. Click Save.
To Next Page
Loading...