IP-COM CPE6S - Wireless Client;Upstream AP

Chapter 5 Status 79
5.3.2 Wireless client/Upstream AP
This module differs depending on the working mode of the CPE.
In AP, Router, P2MP or Repeater mode, it displays information of connected wireless clients.
To access the page, choose Status, then Wireless Client in Statistics part.
Parameters description
Name
Description
IP Address
It specifies the IP address of the corresponding wireless client.
MAC Address
It specifies the MAC address of the corresponding wireless client.
Signal/Noise
It specifies the WiFi signal strength and electromagnet interference signal
strength of the corresponding wireless client.
Transmit/Receive
It specifies the transmitting and receiving rate of the corresponding client.
CCQ
It specifies the connection quality of the corresponding client. A higher
percentage indicates a better connection quality.
Connection Duration
It specifies the time that has elapsed since the wireless client is connected to the
wireless network of the device.
In Client, Universal Repeater or WISP mode, it displays information of upstream AP.
To access the page, choose Status, then Upstream AP in Statistics part.