IP-COM CPE6S - Tools; Date & Time; Synchronized with the Internet

Chapter 9 Tools 170
9 Tools
9.1 Date & time
This module enables you to set the system time of the CPE.
Ensure that the system time of the CPE is correct, so that logs can be recorded correctly and
the reboot schedule can be executed correctly.
Choose Tools > Date & Time to enter the page.
The CPE allows you to set the system time by synchronizing the time with the internet or
manually setting the time. By default, it is configured to synchronize the system time with the
internet.
Tip
When you log in to the web UI of the CPE, the system time will be synchronized with the time of the
management host automatically no matter which time setting method you choose.
9.1.1 Synchronized with the Internet
The CPE automatically synchronizes its system time with a time server of the internet. This
enables the CPE to automatically correct its system time after being connected to the internet.
For details about how to connect the CPE to the internet, refer to the configuration procedure
of corresponding mode in Quick Setup.
Configuration procedure:
1. Choose Tools > Date & Time to enter the configuration page.
2. Set Time settings to Synchronized with the Internet.
3. Specify a time interval. The default value 30 minutes is recommended.
4. Set Time Zone to your time zone.
5. Click Save.