Chapter 4 Quick setup 23
4 Quick setup
This module enables you to quickly configure the CPE or change the working mode of the CPE
to deploy your wireless network.
The CPE supports the following operating modes:
− AP: In this mode, the CPE creates a wireless network based on the current wired network.
− Client: In this mode, the CPE works as a wireless adapter to connect to the wireless network
of upstream AP. Working in the Client mode, the CPE does not provide wireless access
service, and a client device needs to be connected to the CPE with an Ethernet cable.
− Universal Repeater: In this mode, the CPE extends an existing wireless network for broader
network coverage. The new wireless network has the same SSID, password, and related
wireless information as the upstream wireless network.
− WISP: In this mode, the CPE connects to a hotspot provided by ISP in a wireless manner, and
provides the wireless network. The CPE can also be connected to the wireless network of
the upstream wireless router to obtain the IP address by DHCP (Dynamic IP), static IP
address or PPPoE for internet access.
− Repeater: In this mode, the CPE connects multiple wired networks through wireless bridge,
and provides wireless access point.
− P2MP: In this mode, the CPE connects multiple wired networks through wireless bridge, but
does not provide wireless access point.
− Router: In this mode, the CPE connects to a modem in a wired manner, and provides a
wireless network.
To Next Page
Loading...