Chapter 4 Quick setup 48
(7) Set an IP address belonging to a different network segment as that of your ISP hotspot.
For example, if the IP address of your ISP hotspot is 192.168.2.1, you can set this device’s
IP address to 192.168.X.1 (X ranges from 0 to 254 excluding 2) which is also the login IP
address of the CPE. Then click Next.
(8) Click Save, and wait until the CPE reboots to activate the settings.
When LED1, LED2, and LED3 of the CPE are blinking, the CPE is connected to your ISP hotspot
successfully.
2. Set the wireless router.
(1) Log in to the Wed UI of the router.
(2) Select Dynamic IP as the Internet Connection Type, and save the settings.
----End
To Next Page
Loading...