JR XG 14 - Page 59

57
⿟ Curve Mixing
By default, this is set to “INH”. Select CURVE for using this Program Mixing. To “INH” this function, move the
cursor to the Master/Slave channel selection, then press the CLR key.
፧
Curve Point Setting
It is possible to set up to seven (7) mixing curve points at desired positions. Initially, there are three curve
points set - a Low point, Center point and High point. To add more points, select the Master channel and
press the ADD key. Or to delete a point, use the DEL key. To change the value at a point, move the cursor to
the location where you wish to make the change then press to inverse the display, and input the numeric
value.
፧
Exponential Function (EXP)
By setting the Exponential, each point connection become smooth and mild.
TIPS
⿟ By activating the Exponential function, it is possible to smooth the transition between points on the curve.
Function▋List
Current positionMaster channel Slave channel
Mixing value
Master channel Slave channel
Mixing Offset on reference point
Switch Selection
In put Position and
Output Position of
Each Adjustment
Point
Point Addition and Deletion
Flight Mode
This changes the point
Connections to a Curve
Numerical Display of Stick Input Position
and Output Position
Switch Selection