8─61
Noise Level
1. Main
140
0. EXIT
2. Setting Mode
OFF
Noise Level Setting (Noise Level)
[1] Setting the noise level for signal processing (Main)
Procedures 1 When the Adjust Menu appears, press
[9] key.
The SP/ATA INIT Setup Menu will appear.
2 Press [1] key.
The Noise Level Menu will appear.
3 Press [1] key.
The Code Input Menu will open to change the
noise level value.
4 Change the value to display echo
correctly.
In addition to the entry on the Code Input menu,
the Multi-functional Dial Control is available to
change the value.
Exit 1 Press [RADAR MENU] key.
The Main Menu will reappear.
To Next Page
Loading...
