JMA-9100 Instruction Manual > 3.BASIC OPERATION > 3.1 OPERATION FLOW
3ļ¼5
3
3.1.5 End the Operation and Stop the System
Exit
1) Press [TX/STBY] key.
The radar will stop transmission and the antenna will stop rotating.
at the upper left of the radar display changes to .
2) Press [POWER] key.
The system will be turned off.
Maintain the standby state if radar observation is restarted in a
relatively short time.Only pressing the [TX/STBY] key starts
observation.
!
ā¢ When conducting maintenance work, make sure to turn
off the power and make the main breaker OFF so that the
power supply to the equipment is completely cut off.
ā¢ Some equipment components can carry electrical
current even after the power switch is turned off, and
conducting maintenance work without unplugging the
power connector may result in electrocution, equipment
failure, or accidents.
Transmit Standby
i
To Next Page
Loading...
Need help?
General
