JRC JMA-9110-6XA - Ais Operation; Restrictions; Setting AIS Display Function (AIS Function)

JMA-9100 Instruction Manual > 5.OPERATION OF TARGET TRACKING AND AIS > 5.3 AIS OPERATION
5－27
5
5.3 AIS OPERATION
5.3.1 Restrictions
The following restrictions are placed on use of the AIS function.
The AIS function is unavailable in the following cases:
• or is selected for the speed sensor.
• The current offset (Set/Drift Setting) is set while or is selected
for the speed sensor.
• The GPS geodetic system is used except WGS-84.
or cannot be selected for the speed sensor in the following case:
• The AIS function is turned on and the current offset (Set/Drift Setting) is
selected.
cannot be selected for the speed sensor in the following case:
• The AIS function is On.
Current offset (Set/Drift Setting) cannot be turned On in the following case:
• or is selected for the speed sensor while the AIS function is on.
5.3.2 Setting AIS Display Function (AIS Function)
Procedures
1) Press the [AIS/TT] key. Alternatively, left-click the button
in the Target Information located at the upper right of the display.
The received AIS information will be shown on the radar display.
• When the AIS function is set to Off, the AIS display
function is turned off and AIS symbols are no longer
displayed.
• Once the AIS display function is set to Off, it is not
automatically switched to On even if a dangerous
target exists.
MAN
REF.
LOG
2AXW
LOG
2AXW
MAN
LOG
2AXW
Attentio n
AIS