3ļ¼120
JMA-9100 Instruction Manual > 3.BASIC OPERATION > 3.11 USING CARD
3.11 USING CARD
This radar has two card slots. Inserting a flash memory card (option) into a card
slot, you can save the following contents, saved in the processor, in the card or can
load data from the card to the processor.
These pieces of information can be saved in a flash memory card as a file. The
internal capacity is as large as only a file. An internally created file can be saved
until the flash memory card is full.
3.11.1 Operate File on the Card (File Manager)
Procedures
1) Insert a flash memory card into the card slot.
Flash memory card (option) is necessary.
2) Set the radar in the standby state.
While the radar is in the transmission state, the File Manager screen cannot be opened.
3) Open the File Manager window by performing the menu
operation below.
āć
Trails of own ship: 7000 points maximum
Track of other ship: 20 target X 500 points
Mark/Line: 20000 points maximum
WPT: 512 points maximum
Route: 1 route maximum
Main
2. File Manager
To Next Page
Loading...
Need help?
General
