3ļ¼98
JMA-9100 Instruction Manual > 3.BASIC OPERATION > 3.8 APPLIED OPERATIONS
3.8.3.4 Ice Class Standby Mode
ā¢ In this mode, the antenna is rotated when transmission is in the standby state.
ā¢ This mode is effective to prevent the antenna's rotating shaft from freezing.
3.8.4 Set Cursor (Cursor Setting)
This function enables the setting of detail information about cursor operation and
display.
Procedures
1) Open the Cursor Setting menu by performing the menu operation
below.
āć
āć
ā
The Cursor Setting menu will appear.
Detail information about cursor operation and display can be set by changing the settings of
the menu items.
3.8.4.1 EBL/VRM Control Cursor
ā¢ The EBL/VRM Control Cursor is switched between Valid and Invalid.
ā¢ The trackball is provided as a standard device. If the trackball malfunctions, the
cursor can be moved by using the [EBL] dial and [VRM] dial.
ā¢ The cursor moves horizontally when [EBL] is operated, and moves vertically
when [VRM] is operated.
ā¢ To switch between EBL/VRM operation and cursor operation while ON is
selected, hold down the [EBL] dial for 2 seconds.
:The ice class standby mode is not used. When transmission is
in the standby state, the antenna also stops rotating.
:The ice class standby mode is used. When transmission is in
the standby state, the antenna rotates.
: Cursor is operated using a [EBL] [VRM] dial.
: Cursor is operated using a trackball.
Off
On
Main
7. Sub Menu
9. EBL/Cursor Setting
3. Cursor Setting
On
Off
To Next Page
Loading...
Need help?
General
