5ļ¼26
JMA-9100 Instruction Manual > 5.OPERATION OF TARGET TRACKING AND AIS > 5.2 TARGET TRACKING OPERATION
5.2.7.4 Gate Display
The gate displays an area monitoring a target using the Target Tracking function.
This radar equipment allows the gate size to change automatically according to
target range and size. User can check the gate size using the following function.
Procedures
1) Open the TT Test Menu by performing the following menu
operation.
ā
2) Left-click the item button of .
The gate display mode is switched.
3) Display the numeric value of a target according to Section 5.2.3
"Tracked Target Data Display [TGT DATA]" .
The numeric value of the target will be displayed, and the tracked target symbol will be
enclosed in a green gate.
: Gate is displayed
: Gate is not displayed
i
The Target Tracking can display the gate of two targets
simultaneously.
TT
9. TT Test Menu
4. Gate Display
On
Off
Tracked Target symbol
Echo Gate (displayed in green
To Next Page
Loading...
Need help?
General
