JMA-9100 Instruction Manual > 3.BASIC OPERATION > 3.7 USE ROUTE FUNCTION
3ļ¼85
3
3.7.6.4 Displaying bearing distance to the Waypoint (Status of Origin/DEST)
Select a start point used to display bearing/distance in the Waypoint data display area.
Procedures
1) Open the Next menu by performing the menu operation below.
āć
āć
2) Left-click the set value of the item, and
select an operation mode.
3.7.6.5 ON/OFF of Waypoint number display (WPT Number Display)
Set whether to display a Waypoint number next to the Waypoint mark.
Procedures
1) Open the Next menu by performing the menu operation below.
āć
āć
2) Left-click the set value of the item, and
select an operation mode.
:The bearing distance from the own ship position
to next Waypoint is displayed.
:The bearing distance from the previous Waypoint
to next Waypoint is displayed.
: The Waypoint number is not displayed.
: The Waypoint number is displayed.
Route
2. WPT/Route Setting
9. Next
3. Status of Origin/DEST
From CURR POSN
Fix
Route
2. WPT/Route Setting
9. Next
4. WPT Number Display
Off
On
To Next Page
Loading...
Need help?
General
