3ļ¼96
JMA-9100 Instruction Manual > 3.BASIC OPERATION > 3.8 APPLIED OPERATIONS
3.8.2.3 Trails Reduction
ā¢ Make a setting for thinning radar trails.
ā¢ The effect of thinning increases in order of ā ā
.
ā¢ Radar videos do not become obscure because of the thinning of radar trails.
3.8.2.4 Trails Process
ā¢ Determine whether to use the video process with radar signals for plotting
radar trails.
ā¢ When Trails Process is , radar trails are never plotted with unwanted
waves, but the radar trails of moving targets may not be plotted.
ā¢ When Trails Process is , radar trails may be plotted with unwanted
waves, but the radar trails of moving targets are always plotted.
3.8.2.5 MAX Interval
ā¢ Select the maximum time for displaying radar trails.
ā¢ Select when short radar trails are often used in bays and the likes.
ā¢ Select when long radar trails are necessary for ocean navigation.
: Disables the Trails Reduction function.
: Enables the Trails Reduction function. (Effect: Low)
: Enables the Trails Reduction function. (Effect: Modest)
: Enables the Trails Reduction function. (Effect: High)
: Disables the Trails Process function.
: Enables the Trails Process function.
: Sets 15 minutes as the maximum time for radar trails display.
: Sets 30 minutes as the maximum time for radar trails display.
: Sets 60 minutes as the maximum time for radar trails display.
Level1 Level2
Level3
Off
Level1
Level2
Level3
On
Off
Off
On
Short
Long
Short
Middle
Long
To Next Page
Loading...
Need help?
General
