JMA-9100 Instruction Manual > 7.SETTINGS FOR SYSTEM OPERATION > 7.2 SETTINGS
7ļ¼25
7
4) Click the item button corresponding to the item to be changed.
The item is switched.
7.2.9.6 Setting the Alarm Buzzer (Sound Output Mode)
This function enables the control of alarm buzzer.
Procedures
1) Open the Serviceman Menu.
2) Perform the following menu open procedure to open the External
ACK Setting menu.
ā
ā
3) Select the function to be used.
, and
Setting and Ararm Function
ā : Followed by Buzzer Volume menu setting.
ā”: Alarm Buzzer is turned off.
ā¢: If Relay Output menu is turned on when Alam Buzzer is turned off. If Relay Output menu is turned off when Alam
Buzzer is turned on.
ććFor how to setting Buzzer Volume menu, see Section 3.8.6 "Adjust Sound Volume (Buzzer Volume)".
: Setting of alarm sound.
ā
: The alarm sound is not stopped when
acknowridgement have received.
ā
: The alarm sound is stopped when
acknowridgement have received.
: Setting of alarm indication.
ā
: The alarm indication brinking is stopped when
acknowridgement have received.
ā
: The alarm indication brinking is not stopped
when acknowridgement have received.ć
: Setting of ALR sentence.
ā
: Add acknowridgement to ALR sentence.
ā
: Add no acknowridgement (unrecognized) to ALR
sentence.
Alarm Setting
Operation Operation
Miss
CPA/ć
TCPA
New ć
Tar g et
Lost NAV System ISW
ā
ā ā”
ā ā¢ā ā”ā
Audio
On
Off
Indication
Lightning
Brinking
Acknowledge State
A;ACK
V;UNACK
2. Installation Menu
6. Alarm System
4. Sound Output Mode
On
Off 1 Off 2
On
Off 1
Off 2
To Next Page
Loading...
Need help?
General
