No. Item
Setting range
Edit unit
Initial display
Shirring release switch use selection
Use of shirring release switch is selected.
– – – – – – Used as
shirring
release
: Unused
: Used as shirring release
: Used as reverse feed stitching
: Used both as shirring release and thread trim-
ming prohibition
: Used both as reverse stitching and thread
trimming prohibition
* In case the switch is used as the reverse stitching one,
shirring release button is displayed on the panel when the
display setting is performed with
Reverse stitch-
ing button display selection.
* This setting will become invalid for the manual mode.
Knee switch use selection
Whether knee switch for step changeover is used or not is selected.
: Unused : Use
– – – – – – Use
Shirring amount interlock function at the time of
change of pitch selection
Whether shirring amount set to each step at the time of
change of pitch is corrected or not according to the change
amount of pitch is selected.
: Not correct : Correct
– – – – – –
No change-
over
Screen changeover function at the time of thread trim-
ming on the way selection
Whether screen is changed over or not when thread trimming is
performed at the step other than the last step is selected.
: No changeover : Changeover
– – – – – –
No change-
over
Auxiliary feed input mode selection
Whether auxiliary feed input is performed with offset nu-
merical value or % ratio is selected.
: Numerical value : Ratio
– – – – – – Numerical
value
Shirring amount increase/decrease input mode
Whether Shirring amount increase/decrease value
input is performed with offset numerical value or with %
ratio is selected.
: Numerical value : Ratio
0 to 200 1 Numerical
value
Start position change way selection
Whether the change of start position is interlocked with shirring
data or only the start position moves is selected.
– – – – – –
Interlocked
with shirring
data
: Interlocked with shirring data
: Only start position moves.
To Next Page
Loading...
