No. Item
Setting range
Edit unit
Initial display
Reverse rotation to lift needle after thread trimming
function selection
Sewing machine is rotated in the reverse direction after
thread trimming, and needle bar is lifted near to its upper
dead point.
: Ineffective : Effective
– – – – – –
Ineffective
Reverse stitching at the sewing start A/M changeover
function selection
Designation of sewing speed of reverse stitching at the sew-
ing start is selected.
– – – – – – Speed by
manual
operation
: In accordance with the speed by manual
operation of pedal or the like
: In accordance with the speed set by
Reverse stitching speed
Stop function immediately after reverse stitching at the
sewing start selection
Function to make the sewing machine stop once when re-
verse stitching at the sewing start is completed
: Without function : With function
– – – – – – Without
function
Condensation/EBT changeover speed
Initial speed at the time of start of EBT (reverse
stitching at the sewing end) is set.
0 to 250 10sti/min 170sti/min
Retry function selection
Function to make the sewing machine rotate again in the
normal direction with max. torque after rotating the machine
in the reverse direction once when the sewing machine is
locked is selected.
: Without retry function
: With retry function
– – – – – – Without
retry func-
tion
Sewing machine start-up curve selection
Start-up curve of the sewing machine is selected.
: Normal curve : More sharp curve
– – – – – – Normal
curve
Presser position at the time of stop of the sewing ma-
chine selection
Position of the presser foot when the sewing machine tem-
porarily stopped is selected.
: DOWN : UP
– – – – – – DOWN
Size class setting
Initial value (size country class, gents'/ladies'
selection, and basic size) when creating a
new pattern is set.
/
Refer to
"
14-5 Explanation of the size class"
.
– – – – – –
Japan
Gentlemen
No. 6
3%
Initial pitch setting
Initial value of pitch when creating a new pat-
tern is set.
1.5
to
6.0 0.1mm 2.0mm
Bottom feed amount compensation value
setting
Compensation value of set value and actual
value of bottom feed amount is set.
–1.0 to 1.0 0.1mm 0mm
To Next Page
Loading...
