CHAPTER 8
Port and Interface Specifications
•
USB Port Specifications for the QFX Series on page 83
•
Console Port Connector Pinouts for the QFX Series on page 84
•
Management Port Connector Pinouts for the QFX Series on page 85
•
Interface Support for the QFX5100 Device on page 86
•
Interface Specifications for SFP, SFP+, and QSFP+ Transceivers for the QFX
Series on page 94
•
Interface Specifications for SFP+ DAC Cables for the QFX Series on page 126
•
Interface Specifications for SFP+ and QSFP+ Active Optical Cables for the
QFX5100 on page 132
•
Interface Specifications for QSFP+ to SFP+ Active Optical Breakout Cables for the
QFX5100 on page 134
•
Interface Specifications for QSFP+ DAC Breakout Cables for the QFX Series on page 135
•
Interface Specifications for QSFP+ DAC Cables for the QFX Series on page 140
USB Port Specifications for the QFX Series
The following Juniper Networks USB flash drives have been tested and are officially
supported for the USB port in the QFX Series:
•
RE-USB-1G-S—1-gigabyte (GB) USB flash drive (except QFX3100 Director device)
•
RE-USB-2G-S—2-GB USB flash drive (except QFX3100 Director device)
•
RE-USB-4G-S—4-GB USB flash drive
CAUTION: Any USB memory product not listed as supported for the QFX
Series has not been tested by Juniper Networks. The use of any unsupported
USB memory product could expose your device to unpredictable behavior.
Juniper Networks Technical Assistance Center(JTAC)can provide only limited
support forissues relatedtounsupportedhardware. We stronglyrecommend
that you use only supported USB flash drives.
83Copyright © 2016, Juniper Networks, Inc.
To Next Page
Loading...
