Juniper QFX5100 - Interface Alarm Messages

Related
Documentation
Chassis Alarm Messages on a QFX3008-I Interconnect Device•
• Chassis Alarm Messages on a QFX3500 Device
• Interface Alarm Messages on page 234
• show chassis alarms
• show system alarms
Interface Alarm Messages
Interface alarms are alarms that you configure to alert you when an interface is down.
To configure an interface link-down condition to trigger a red or yellow alarm, or to
configure the link-down condition to be ignored, use the alarm statement at the [edit
chassis] hierarchy level. You can specify the ethernet, fibre-channel, or
management-ethernet interface type.
NOTE: Fibre Channel alarms are only valid on QFX3500 devices.
NOTE: Whenredalarms or majoralarmsare issued onQFX5100and EX4600
switches, the alarm LED glows amber instead of red.
By default, major alarms are configured for interface link-down conditions on the control
plane and management network interfaces in a QFabric system. The link-down alarms
indicate that connectivity to the control plane network is down. You can configure these
alarms to be ignored using the alarm statement at the [edit chassis] hierarchy level.
NOTE: If youconfigure ayellow alarm onthe QFX3008-I Interconnect device,
it will be handled as a red alarm.
Related
Documentation
• Understanding Alarms on page 233
Copyright © 2016, Juniper Networks, Inc.234
QFX5100 Switch Hardware Guide