Varning! Denna utrustning ska endast installeras och bytas ut av utbildad
och kvalificerad personal.
Related
Documentation
General Safety Guidelines and Warnings on page 239•
• General Electrical Safety Guidelines and Warnings on page 261
• AC Power Electrical Safety Guidelines on page 264
• DC Power Electrical Safety Guidelines for Switches on page 266
Warning Statement for Norway and Sweden
WARNING: The equipment must be connected to an earthed mains
socket-outlet.
Advarsel Apparatet skal kobles til en jordet stikkontakt.
Varning! Apparaten skall anslutas till jordat nätuttag.
Related
Documentation
General Safety Guidelines and Warnings on page 239•
Fire Safety Requirements
•
Fire Safety Requirements on page 243
Fire Safety Requirements
In the event of a fire emergency, the safety of people is the primary concern. You should
establish procedures for protecting people in the event of a fireemergency, provide safety
training, and properly provision fire-control equipment and fire extinguishers.
In addition, you should establish procedures to protect your equipment in the event of a
fire emergency. Juniper Networks products should be installed in an environment suitable
for electronic equipment. We recommend that fire suppression equipment be available
in the event of a fire in the vicinity of the equipment and that all local fire, safety, and
electrical codes and ordinances be observed when youinstall and operate your equipment.
Fire Suppression
In the event of an electrical hazard or an electrical fire, you should first turn power off to
the equipmentat the source. Then use a Type C fire extinguisher, which uses noncorrosive
fire retardants, to extinguish the fire.
Fire Suppression Equipment
Type C fire extinguishers, which use noncorrosive fire retardants such as carbon dioxide
and Halotron™, are most effective for suppressing electrical fires. Type C fire extinguishers
243Copyright © 2016, Juniper Networks, Inc.
Chapter 24: Safety and Compliance Information
To Next Page
Loading...
