¡Atención! El desecho final de este producto debe realizarse según todas las
leyes y regulaciones nacionales
Varning! Slutlig kassering av denna produkt börskötas ienlighetmed landets
alla lagar och föreskrifter.
Related
Documentation
General Safety Guidelines and Warnings on page 239•
• General Electrical Safety Guidelines and Warnings on page 261
• AC Power Electrical Safety Guidelines on page 264
• DC Power Electrical Safety Guidelines for Switches on page 266
• Laser and LED Safety Guidelines and Warnings
• Installation Instructions Warning on page 248
• Grounded Equipment Warning on page 255
Power and Electrical Safety Information
•
General Electrical Safety Guidelines and Warnings on page 261
•
Prevention of Electrostatic Discharge Damage on page 263
•
AC Power Electrical Safety Guidelines on page 264
•
AC Power Disconnection Warning on page 265
•
DC Power Electrical Safety Guidelines for Switches on page 266
•
DC Power Disconnection Warning on page 268
•
DC Power Grounding Requirements and Warning on page 269
•
DC Power Wiring Sequence Warning on page 270
•
DC Power Wiring Terminations Warning on page 272
•
Multiple Power Supplies Disconnection Warning on page 273
•
TN Power Warning on page 273
•
Action to Take After an Electrical Accident on page 274
General Electrical Safety Guidelines and Warnings
WARNING: Certain ports on the device are designed for use as intrabuilding
(within-the-building) interfaces only (Type 2 or Type 4 ports as described in
GR-1089-CORE) and require isolation from the exposed outside plant (OSP)
cabling. To comply with NEBS requirements and protect against lightning
surges and commercial power disturbances, the intrabuilding ports must not
be metallically connected to interfaces that connect to the OSP or its wiring.
The intrabuilding ports on the device are suitable for connection to
intrabuilding or unexposed wiring or cabling only. The addition of primary
261Copyright © 2016, Juniper Networks, Inc.
Chapter 24: Safety and Compliance Information
To Next Page
Loading...
