Juniper QFX5100 - Connecting DC Power to a QFX5100 Device

Table 56: Cable Specification for 10GBASE-T Network Ports
Additional
Information
Frequency
(MHz)
Maximum
Reach
Cable Standard
Specification
Shield or
Unshielded
Twisted
Pair
(STP/UTP)
IEEE Cable
Standard
Ports on
Switches
1–600328 ft
(100 m)
ISO/IEC 11801:2002STPClass F/ CAT 710GBASE-T
1–500328 ft
(100 m)
ANSI/TIA/EIA-568-B2-10STP/UTPClass EA/
CAT 6A
CAT 6 cables
are defined to
perform at
frequencies up
to 250 MHz and
are sensitive to
alien crosstalk.
To use such
cables to
connect to
10GBASE-T
ports, you must
ensure that the
cable
installation is
tested and is
certified for
500 MHz as per
TIA TSB-155
standard.
1–25098 ft (30m)ANSI/TIA/EIA 568-B.2-1UTPClass E/ CAT 6
1–25098 ft (30m)ANSI/TIA/EIA 568-B.2-1STPClass E/ CAT 6
1-100
1-250
1-500
328 ft
(100 m)
ANSI/TIA/EIA-568-A
ANSI/TIA/EIA-568-B.2-1
ANSI/TIA/EIA-568-B2-10
STP/UTPCAT 5e
CAT 6
CAT 6A
(STP/UTP)
1000BASE-T
1-100
1-250
1-500
328 ft
(100 m)
ANSI/TIA/EIA-568-A
ANSI/TIA/EIA-568-B.2-1
ANSI/TIA/EIA-568-B2-10
STP/UTPCAT 5e
CAT 6
CAT 6A
(STP/UTP)
100BASE-TX
Related
Documentation
• Port Panel of a QFX5100-48T Device on page 30
• QFX5100 Device Hardware Overview on page 3
Copyright © 2016, Juniper Networks, Inc.154
QFX5100 Switch Hardware Guide