Port Panel of a QFX5100-96S Device
The port panel of the QFX5100-96S switch consists of 96 small form-factor pluggable
plus (SFP+) and 8 quad small-form factor pluggable plus (QSFP+) ports. Physical
ports(0 through 95) support 10 Gbps SFP+ transceivers and normally are configured as
access ports. The eight 40-Gigabit ports (96 through 104) support QSFP+ transceivers
and are normally configured as uplinks or Virtual Chassis ports (VCPs). Although the 104
physical ports of the QFX5100-96S would map to 128 logical ports using channelization,
only 104 logical ports are supported.
Figure 18 on page 32 shows the port panel of a QFX5100-96S switch.
Figure 18: QFX5100-96S Switch Port Panel
3—1— 40 Gigabit Ethernet ports (8)Electrostatic Discharge (ESD) terminal
2—10 Gigabit Ethernet ports (96)
This topic describes:
•
Switch Ports on page 32
•
Channelizing Interfaces on page 33
•
Virtual Chassis and Virtual Chassis Fabric Support on page 33
Switch Ports
The QFX5100-96S switch ports, (0 through 95) support:
•
1 Gbps SFP+ transceivers
•
10 Gbps SFP+ transceivers
•
10 Gbps direct attach copper (DAC) cables
Ports 96 through 104 support:
•
40 Gbps QSFP+ transceivers
Additionally ports 96 and 100 support:
•
QSFP+ direct attach copper (DAC) cables
•
QSFP+ to SFP+ direct attach copper break out (DACBO) cables
Copyright © 2016, Juniper Networks, Inc.32
QFX5100 Switch Hardware Guide
To Next Page
Loading...
