EasyManua.ls Logo

Juniper QFX5100 - Figure 2: QFX5100-48 T Port Panel; System Overview

Juniper QFX5100
300 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
redundant power supplies. The switch can be ordered with either ports-to-FRUs or
FRUs-to-ports airflow and with AC or DC power supplies.
Figure 2: QFX5100-48T Port Panel
The QFX5100-48T can be used as:
A standalone switch.
A Node device in a QFabric system.
The QFX5100-48T is supported on both the QFX3000-G and QFX3000-M QFabric
systems.
A master, backup, or line card in a QFX Virtual Chassis.
A QFX Series Virtual Chassis allows you to interconnect up to ten QFX5100, QFX3500,
or QFX3600, switches into one logical device and manage the device as a single
chassis using a ring topology.
A leaf device in a Virtual Chassis Fabric (VCF).
VCF uses Virtual Chassis technology to interconnect multiple devices into a single
logical device and manage that device as a single logical device inside of a fabric
architecture. VCF architecture supports up to 20 total devices in a spine and leaf
topology. Of those 20 devices, 4 QFX5100 devices can be configuredas spine devices.
In a VCF, the QFX5100-48T is always a leaf device and a QFX5100-24Q is the spine
device.
A satellite device in a Junos Fusion system.
Junos OS Release 14.2.3 or later is required for Junos Fusion.
QFX5100-24Q
As shown in Figure 3 on page 6, the QFX5100-24Q is a 40-Gigabit Ethernet QSFP+
switch with 24 high-density QSFP+ ports. Each QSFP+ port can operate as a native
40 Gbps port or as 4 independent 10 Gbps ports. The QFX5100-24Q switch has a 1 U
form factor and comes standard with redundant fans and redundant power supplies.
The switch can be ordered with either ports-to-FRUs or FRUs-to-ports airflow and
with AC or DC power supplies.
The QFX5100-24Q switch has two module bays for the optional expansion module,
QFX-EM-4Q, which can add a total of 8 additional QSFP+ ports to the chassis. When
operating as a standalone switch and fully populated with QFX-EM-4Q Expansion
Modules, the QFX5100-24Q switch is equivalent to 80 10 Gbps interfaces and 4
40-Gbps interfaces. Of these total ports, 104 logical ports are available for 10G port
channelization. For full details on the different port channelization modes, see “Port
Panel of a QFX5100-24Q Device” on page 23. All ports on the QFX5100-24Q and
5Copyright © 2016, Juniper Networks, Inc.
Chapter 1: System Overview

Table of Contents

Related product manuals