Juniper QFX5100 - Figure 12: Management Panel Components on the QFX5100-96 S; Chassis Components and Descriptions

Figure 12: Management Panel Components on the QFX5100-96S
4—1— em0–RJ-45 (1000 Base-T) management
Ethernet port (C0)
Status LEDs
5—2— RJ-45 console port (C0N) )em1–SFP management Ethernet port (C1)
Cage (socket for either 1 GbE copper SFP or
fiber SFP)
6—3— USB port
Reset button,seecaution statement above
The management panel consists of the following components:
•
Status LEDs
•
ALM–Alarm
•
Unlit indicates the switch is halted or that there is no alarm.
•
Red indicates a hardware fault, such as a power failure or a system shutdown due
to system over-heating.
•
Amber indicates a major or minor alarm.
•
SYS–System
•
Unlit indicates the switch is powered off or halted.
•
Solid green indicates that Junos OS for QFX Series is loaded on the switch.
•
Blinking green indicates the switch is:
•
A participating member in a Virtual Chassis.
•
A participating leaf device in a Virtual Chassis Fabric (VCF).
•
A participating spine device in a VCF.
•
A Routing Engine Master in a VCF.
•
A Routing Engine Backup in a VCF.
21Copyright © 2016, Juniper Networks, Inc.
Chapter 2: Chassis Components and Descriptions