Juniper QFX5100 - Access Port and Uplink Port Leds on a QFX5100 Device; Table 14: Management Port Leds on a QFX5100 Switch

Table 14: Management Port LEDs on a QFX5100 Switch
DescriptionStateColorLED
No link is established, there is a fault, or the link is down.OffUnlitLink/Activity
A link is established, but there is no link activity.On steadilyGreen
A link is established, and there is link activity.Blinking or flickering
Either the port speed is 10 M or the link is down.OffUnlitStatus
The port speed is 1000 M.On steadilyGreen
The port speed is 100 M.On steadilyAmber
Related
Documentation
Management Panel of a QFX5100 Device on page 19•
• Connecting a QFX5100 Device to a Networkfor Out-of-Band Management on page 180
Access Port and Uplink Port LEDs on a QFX5100 Device
The Link/Activity and Status LED configuration for QFX5100 switches use bi-colored
LEDs. The link LED indicates link activity or a fault. The status LED indicates transceiver
presence. See Table 15 on page 58 to locate the position and type of LED for your QFX5100
model.
57Copyright © 2016, Juniper Networks, Inc.
Chapter 5: Viewing System Information